BL-201 Series Brite Led Tech Lamps
Registered Certified Design No: 319090
|
|
|
|
Fitment for 201 style lamps
The BL-201 style lamps simply remove modules from the black surround by the 2 clips on each module and
remove modules from the rear and position modules where complete lamp will be installed to position holes for
wires to exit
Wire up each module using standard colour codes
earth: white
stop: red
Brown: tail
Yellow: indicator
module itself will have yellow for indicator though on most trailers etc it will have 5 core wire being yellow for left
indicator and green for right so for right side you would connect the yellow from the bl-201 module to the green
on the trailer
Using the plastic guide supplied and mark 2 outer hole positions for one of the modules to be mounted, drill both
holes and fit supplied bolts holding 1 module in place and then use spacer plate to make guide holes for second
module and apply 2 mounting bolts, then remove guide and complete all bolt holes and affix modules once wired
up and then clip over surround,
behind each module there is good sized cavity to do your wire connection and conceal all joins rather than doing
external joins
|
BL-202 Series Brite Led Tech Lamps
Registered Certified Design No: 319855
Can remove red reflector to fit new BL-310M number plate lamp on BL-202, BL-207 and BL-210 series lamps
|
|
|
|
Fitment for 202 style lamps
The BL-202 style lamps simply remove modules from the front surround by the 2 clips on each module and sit
base plate against vehicle where fitting lamp and mark the 2 bolt hole locations and drill holes and affix the base
plate, drill holes for wires and either bring external wires in or feed module wires out through the hole where
rubber grommet is located connect up wires, there is ample spacing behind modules to keep all wire joins within
the lamp area.
Wire up each module using standard colour codes
earth: white
stop: red
Brown: tail
Yellow: indicator
Amber module itself will have yellow for indicator though on most trailers etc it will have 5 core wire being yellow
for left indicator and green for right so for right side you would connect the yellow from the BL-202 module to
the green on the trailer
Sit each module onto base lining up with holes already present for mounting and screw each module to base
plate using the 8 stainless steel screws supplied
Once modules are fixed simply push on the front surround which will clip into place, each module has 2 fixed
moulded clips which align with the clips on front surround, the end clips are guides only and are not used for the
main retaining of the front surround to the base.
|
BL-203 Series Brite Led Tech Lamps
Registered Certified Design No: 318180
|
|
|
Fitment for 203 style lamps
For the BL-203 style lamps simply remove module from the front surround by the 2 clips on module and sit
against vehicle where fitting lamp and mark the 4 bolt hole locations and drill holes also at same time drill holes
for wires to exit and either bring external wires in or feed module wires out through the hole and connect up
wires, there is ample spacing behind modules to keep all wire joins within the lamp area.
Wire up each module using standard colour codes
earth: white
stop: red
Brown: tail
Yellow: indicator
Amber module itself will have yellow for indicator though on most trailers etc it will have 5 core wire being yellow
for left indicator and green for right so for right side you would connect the yellow from the BL-202 module to
the green on the trailer
Sit led module against vehicle lining up with the 4 holes drilled and fix the stainless steel bolts and nuts supplied
Once module is fixed simply push on the front surround which will clip into place
for BL-203ARM and BL-203VARM always mount so the amber is at the top and red stop/tail is beneath
|
